1 - 13x18 Hoop (5x7 Hoop)
2 - Water-Soluble Stabilizer
3 - Hoop Template
4 - 1 T-Shirt
5 - 1 Piece of Voile Fabric measuring 15x10 cm (5.9x3.9 inches)
6 - Magic Pen
7 - Fine Tip Scissors
8 - Masking Tape
9 - Fine Pins
10 - Bobbin Thread matching the wing finishing thread color
11 - Embroidery Threads

1 Poliondas Support Board

Place the SUNFLOWER BUTTERFLY design into the machine and insert the bobbin with the thread matching the wing finishing color

Prepare the hoop with the water-soluble stabilizer

Place the hoop template onto the hoop and use the magic pen to mark the five points

Using the template, make the same markings on the T-shirt as in the previous step

Place the hoop onto the support board

Position the T-shirt over the hoop

Secure a pin at each marked point on the T-shirt and the hoop, attaching them to the support board

Place pins around the hoop as close as possible to the hoop edge so the machine presser foot does not touch them while embroidering. Remove the five pins used to secure the support board

Take it to the machine and stitch the wing placement marking

Place the 15x10 cm (5.9x3.9 inches) voile fabric on the back side of the hoop and secure it with masking tape

Return to the machine and stitch the fabric attachment using the zigzag stitch

Remove the hoop from the machine and remove the masking tape

Trim the excess voile fabric from the back side

Carefully cut the inner part of the wing on the front side of the T-shirt, being careful not to cut the stabilizer

Take it to the machine and embroider the remaining embroidery colors until the design is complete

Remove it from the machine, remove the pins, and take it out of the hoop.

Trim the excess water-soluble stabilizer and place it in water so it can dissolve.

FINISHED!!!
Embroidered elegance to make your look even more special