1- 3,93" × 3,93" embroidery hoop

2 - Tear-away stabilizer

3 - One piece of snow wadding ( 3,14" gsm), 3,14" x 3,14"

4 - Two pieces of felt, 3,14" x 3,14"

5 - Embroidery threads

6 - Fine-point scissors for trimming

7 - Masking tape

8 - Bobbin with thread in the color of the final finish

9 - One acrylic sphere

- Prepare the hoop with the stabilizer.

- Load the Christmas Ball design into the machine and stitch the first color shown in BLACK, which will serve as the marking.

- Place the 3,14" x 3,14" snow wadding and the 3,14" x 3,14" felt over the marking and secure them at the edges with masking tape.

- Put the hoop back on the machine and stitch the second color shown in RED, which will secure the material.

- Keep the hoop in the machine and stitch the third color of the design shown in WHITE.

- After stitching the third color, remove it from the machine and trim the excess felt and wadding.

- On the back side of the hoop, place the 3,14" x 3,14" felt and secure it with masking tape.

- Return to the machine and stitch the fourth color shown in RED, which will secure the backing.

- Remove from the machine and trim the leftover felt.

- Load the bobbin with the thread that matches the final finish color onto the machine.

- Go back to the machine and stitch the last color of the design — this will be the final finish. Remove from the hoop, remove the stabilizer, and clean up the embroidery.

- Fit the finished piece into the recessed part of the acrylic sphere and close it with the other half.

- we finished our project.